p;THESIS CONTENT The thesis should contain the following: 11.1 A title page (refer to page 19) 11.1.1 UNIVERSITY’s logo 11.1.2 Thesis Title 11.1.3 Student Name 11.1.4 Course Title 11.1.5 At the bottom of title page student must show the following statement: “Submitted in Partial Fulfillment of the Requirements for the Degree of Master of Science in (Information Technology - Computer Science - Telecommunication Science - Technology Management), XXX university” 11.1.6 Submission month and year
11.2 An approval page (refer to page 21) 11.2.1 Thesis Title 11.2.2 Student Name 11.2.3 Thesis advisor name 11.2.4 Academic year 11.2.5 Student must show the following statement: “The Department of (IT-CS-TS-TM), the Faculty of Science and Technology of XXX university has approved this thesis of twelve course credits, (IT-CS-TS-TM) 7000 Master Thesis, submitted in partial fulfillment of the requirements for the degree of Master of Science in (1T-CS-TS-TM).” 11.2.6 Approval Committee names.
11.3 Acknowledgement Its usual to acknowledge your advisor (and co-advisor, if any) and help given by Technical Support Staff and others as appropriate at the start of thesis.
11.4 Abstract A short summary (100-200 words) distilled from the introduction, conclusion and recommendation of your thesis after the thesis is written.
11.5 Tab英语论文网 【http://www.51lunwen.org】le of contents (refer to appendix 6) 11.5.1 “Table of Contents” in bold upper case sizes 16 font in the middle of page (center). 11.5.2 Acknowledgments, abstract, list of figures, list of tables must be in upper case without bold and use Roman numerals to number their pages. 11.5.3 All chapter topics should be written in upper case without bold 11.5.4 Subtopics written in each chapter should be numbered using Arabic nu¬merals and indented one tab as shown below. CHAPTER 1 INTRODUCTION 1.1 Background of the thesis 1.2 Thesis problems 1.3 ………
11.6 List of figures (refer to appendix 6) 11.6.1 Upper case “List of Figures” with bold size 16 font. 11.6.2 “Figure” must be shown as Figure 1-1, Figure 1-2,. Figure 2-1 and so on 11.7 List of tables (refer to appendix 6) 11.7.1 Upper case “List of Tables” with bold size 16 11.7.2 “Table” must be shown as Table 1-1. Table 1-2,. Table 2-1 and so on
11.8 Bibliography and references (refer to appendix 5) A bibliography is a complete list of books and paper that you have consulted. The following format should be applied; 11.8.1 Books One author [35] Smith, Gerald M. Statistical Process Control and Quality Improvement, 3rd Edition. New Jersey: Prentice Hall Inter¬national Inc., 1998.
Two or more authors [17] Gonzalez, Rafael C., and Richard E. Woods. Digita
本文来自:英语论文网 【http://www.51lunwen.org】 |